For 0.2mm user : use the cleaning pin attached to the eraser.
For 0.3mm or bigger diameter user : use the refill lead.
For more information : See 「 How to Clear a Lead Jam 」.
1
Before writing, click the end cap until the lead shows from the pipe.
2
Press the end cap down with your finger, and at the same time gently touch the lead to the surface of the paper until the protruding lead is no longer visible. Now you can start writing.
3
When writing, make sure that no lead protrudes out of the pipe. Advancing too much lead may cause the lead to break during writing.
4
The pipe protects the lead and prevents it from breaking.The edge of pipe is rounded to provide smooth writing without scratching the paper. As the lead gradually shortens, the pipe automatically slides back with the lead. No need to advance this lead AGAIN.
When the pipe slides back completely, click ONLY ONCE to advance the lead. If the pipe slides back after clicking once, the lead is too short. The remaining short piece of lead may cause a lead jam. Please remove this lead.
See [ Removing the Remaining Short Piece of Lead ]
When the lead shortens too much, the pipe will suddenly retract while you are writing. The remaining short piece of lead may cause a jam. Please click until the short piece of lead comes out.
When you have finished writing, please retract the pipe fully.
Press the end cap down with your finger, and at the same time gently touch the pipe to the surface of the paper. Retracting the pipe fully prevents damage to your belongings or injury.
For 0.2mm user : use the cleaning pin attached to the eraser.
For 0.3mm or bigger diameter user : use the refill lead.
For more information : See 「 How to Clear a Lead Jam 」.